Delta Electronics Network Device DOP-B User Manual download pdf (Page 4)

English-3

 For use on a flat surface of a Type 4X "Indoor Use Only" enclosure or equivalent.

 The allowable thickness of the panel for mounting should be less than 5 mm.

Installation Method:

Step 1:

Ensure to put waterproof gasket into HMI and

then insert the HMI into the panel cutout.

Step 2:

Ensure to insert fasteners into the HMI’s insertion

slots and turn the screw till screws touch panel

cutout.

Step 3:

Turn the screw with less than torque 0.7N.M to

avoid damage to plastic box.

Torque: 6.17lb-inch (0.7N-M)

Step 4:

Keep at least 60mm distance from rear of HMI

product to the wall, installation surface or the other

controllers for heat dissipation.

The size of the fastener.

16.3

Wiring

Recommended wiring is in the table below:

Type Wire Gauge (AWG) Stripped length Torque

Solid

28 ~ 12 7 ~ 8 mm

5 kg-cm (4.3 lb-in)

Stranded 30 ~ 12 7 ~ 8 mm 5 kg-cm (4.3 lb-in)

Units: mm

1 2 3 4 5 6 7 8 9 ... 42 43

No comments

Delta Electronics Network Device DOP-B User Manual Page 4